The open-loop gain in the simulation result (59.9V/mV) is smaller than the minimum value (70V/mV) in the datasheet. Does this mean that the gain in the SPICE model is smaller than the gain in the ...

We are using TCAN1145-Q1 to judge it is wake up frame from the network or not by CANINT register bit. While we found when there are other nodes receiving WUF, this TCAN1145 node cannot assert register ...

Reg63 ”DAC Channel Volume Control's Soft-Step control”...Soft-Stepping is 1 step per 1 or 2 DAC Word Clock I would like to check whether there is any pop noise when switching from maximum volume to ...

This question is similar to "e2e.ti.com/.../bq25756-driving-the-system-when-the-battery-is-absent", I don't see an answer to that question, so I am asking here. We ...

I am looking for software help on a CAN interface that is on the TI CP3UB26 microcontroller as well as on the NatSemi/TI CR16 family. Does TI have any software drivers for this CAN peripheral? Thank ...

We are using Code Composer Studio Version: 12.8.0.00012 with compiler version 22.6.1LTS, C2000Ware version 5.2.0 and SysConfig version 1.21.0. We have configured two tasks to run on CLA. Basically ...

I'm using the ADC128S102 EVM and I did some measurements I want to save to a log file. I the GUI there is such option but I cant find the location the Log file is generated to. Please help here.

We use gmake tool to build our AM62Ax project in windows operation system, sometimes the compiler report error log as the screenshot show,but if we try to rebuild the ...

The datasheet recommend the ripple ratio is setting as 20%-40%. I am wondering if it can set as 50% if we pass the RA test, time domain test and bode plot in worse ...

But why does this document mention uniflash also can be used on PC side? This make the reader confused.

we use the LM5164 chip on many electronic boards and we are very satisfied. I noticed that typically the impedance of the VIN pin (referred to the GND pin) is around 9MΩ. The measurement is made with ...

For one of the FPGA based Project we're developing power supply using multiple TPS543820E ICs with power supply sequencing. Can anyone help to understand total requirement of bulk capacitor at input ...